Atas Permashake Manual do Utilizador descarregar pdf

Installation Guide

Review and understand complete

guide before beginning installation.

This guide has been prepared as sug-

gested details to particular design condi-

tions. Each condition has certain limitations to perform-

ance, aethetics or economics. Professionals qualified to

assess this information for a specific project, should deter-

mine that the selection and installation are made to their

requirements. ATAS cannot assume any responsibility

for the actual selection and/or installation of materials.

The panels, flashings and trim shown in this guide, illus-

trated over solid and plumb substrate, assume that the

structure has been designed and prepared in accordance

with local building codes.

Permashake panels are simulated wood shakes

manufactured from 29 gauge G90 galvanized steel.

They are available in 6 standard colors with a Hylar 500

and/or Kynar 5000

finish. They measure 10 5/8” (nom.) x

61” (nom.) Minimum recommended roof pitch is 4:12.

Insertion tab at

left end of panel

1” nom. front face with

9/16” nom. tab bent under

1/2” hem on

top surface

Interlock slot on

right end of panel

PANEL INSTALLATION - In environments where ice and water may dam, apply ATA Shield

underlayment over entire substrate. Begin installation

over solid deck by applying ATA Shield

around perimeters of roof with a minimum of 36” coverage. Then apply ATA Guard

or appropriate underlay-

ment over roof deck. Snap a vertical and horizontal line to square up the plane with the eave line. Start at the bottom left hand corner of the roof

plane with a full length panel. Install shingles in a left to right manner from eave to ridge. See below for stagger methods of installation. Fasten

panels to solid substrate with galvanized steel clips using a minimum of three (3) to a panel. Manufacturer recommends the use of 1” wafer head

screws.

Channel trim

STEP STAGGER METHOD

Each course 10” to the left of

the lower course.

Channel trim

RANDOM STAGGER METHOD

Cut and start each course as

follows beginning at the lower left

edge of the roof.

In areas of high winds and / or heavy

snow loads, a clip is recommended

every 12” with 5 clips per panel.

Section through interlocking slot at right end of panel

60” coverage

Interlock slot at right end

10-5/8”

There are twelve (12) Permashake panels packaged per

carton. Approximately twenty-four (24) panels equal a

square. Panels are always installed left to right and

should have a minimum of three (3) anchor clips.

1 2 3 4

Resumo do Conteúdo

Página 1 - Installation Guide

Installation GuideReview and understand completeguide before beginning installation.This guide has been prepared as sug-gested details to particular d

Página 2 - Valley Detail

Gable DetailEave DetailValley Detail1. When applying a re-roof application, cut backexisting shingles and drip edging to be flush witheave and gable l

Página 3 - Hip & Ridge Detail

Hip & Ridge DetailHeadwall Detail Shed Ridge DetailHip and ridge applications are handled in thesame manner.1. Install roo

Página 4 - Sidewall Detail

Pipe DetailStep 1Cut on the proper pipe diam-eter marked on the flashing. Step 2Position over pipe and slidedown the pipe.Step 3Apply polyurethane sea