Atas ScanRoof Manual do Utilizador descarregar pdf

SCANROOF panels are always installed from lower right

of any roof section to upper left. Each fully applied

panel affords 18.1 square feet of coverage and each

square (100 square feet - 5.52 panels) of SCANROOF

weighs approximately 145 pounds.

Minimum roof slope - 3:12.

21 Modules - 13’-10” (nom.) overall length

Lap Area

20 Modules - 13’-2” (nom.) Coverage

7-7/8”

21”

16-1/2” ref.

Top View

FASTENER REQUIREMENTS

SWR8XX - “Stitch Screws” 10 per panel

SWR9XX - 10 for each panel installed at eave

RSS014 or SWR970 - Anchor Screws 8 per panel

(Use RSS014 for attachment to metal and SWR970 for attachment to wood.)

For basic wind speeds of 100 mph - Panels can obtain 140 mph winds

Consult ATAS for more information.

Appropriate

Anchor Screw

Scan Roof Panel

SWR8XX Stitch Screws

Intergral “Z” Purlin

Scan Roof Panel

Substrate

Line

HORIZONTAL LAP

1-1/2” Hat

Channel

2” X 4”

Wood Stud

Open Framing

Solid Substrate

4’ Max

Appropriate

Anchor Screw

SWR8XX Stitch Screws

Intergral “Z” Purlin

Panel Overlap

21” Nom.

16-1/2” (nom.) coverage

2” Nom.

1”

Side View

Installation Guide

Review and understand complete

guide before beginning installation.

This guide has been prepared as

suggested details for particular design

conditions. Each condition has certain

limitations to performance, aesthetics or

economics. Professionals qualified to assess

this information for a specific projects should

determine that the selection and installation are made

to their requirements. ATAS cannot assume any

responsibility for the actual selection and/or installation

of materials. The panels, flashing and trim shown in this

guide are illustrated over solid and square substrate. It

is assumed that the structure has been designed and

prepared in accordance with local building codes,

including appropriate underlayment.

1 2 3 4

Resumo do Conteúdo

Página 1 - Installation Guide

SCANROOF panels are always installed from lower rightof any roof section to upper left. Each fully appliedpanel affords 18.1 square feet of coverage

Página 2 - Valley Detail

Eave DetailGable DetailValley Detail1. In re-roofing applications: cut back and remove the existing shingles and drip edge to be flush with the eave a

Página 3 - Shed Ridge Detail

Hip & Ridge DetailHeadwall DetailShed Ridge DetailHip and ridge applications are handled in the samemanner.1. Install panel to hip/ridge line. Cut

Página 4 - Sidewall Detail

Pipe DetailStep 1Cut on the proper pipediameter marked on the flashing. Step 2Position over pipe andslide down the pipe.Step 3Apply polyurethanesealan